Auria Discussion Board

DM1 does not record through AudioBus into Auria under iOS 8.0.2 either.

Make sure your screen brightness is down to as low as you can stand it. That tends to be the biggest drain on the battery.

Never mind. I see that you and FabFilter are already on the case.

The filters work and I can tab through the presets one at a time.
I know iOS 8 is having a difficult birth and expected problems when I upgraded. Hadn't seen this one mentioned yet.

Tested Pro-Q,C,L
The preset drop downs are only a thin white line.
Does not effect PSP
See pic

IOS 8, iPad Air
Start Auria first, set to AudioBus mode, launch AB then Auria in the output slot
There is a latency mis-match. Tried closing both Auria and AB launch Auria set latency to 256, launch AB set Auria in output. AB says 512, Auria 256.

Had an iTrack for a month. Nice bit of kit. Plugged in an Axiom Air 25. Works. Able to run a guitar, an AT2020 mic, and the Axiom simultaneously.

Your interface is a factor. Plug into the headphone jack or a bus powered interface? then you probably need to keep the headphone impedance at less than 50 ohms. Powered interface with a good hp amp then the 600 ohm sets become possible.

You would need a Lightning to 30 pin adapter and they don't appear to exist.

The excellent how to synch to Genome thread surfaced again today
http://auriaapp.com/forum/viewtopic.php?f=19&t=11760

Blender is free.
Http://blender.org

Route the output to a new track and record that? May be a simpler way but that works for me.

Yes indeed. Thank You!

This has me puzzled also.

Just load a blank project before closing Auria for the day.