Is the a way to define an end point on a song? I have a song that ends around the 79th measure but when I did the mix down it ran much further than that. Also, when I run to the end of the track it goes far beyond where the music ends. I've tried looking through the user manual and haven't seen anything.
Thank you
Setting an end point
Re: Setting an end point
Hello you can set locater points- just to left of transport control then
in mixdown window select "locater range" and Auria will stop the mix at the
locater out point
best of luck- good sounds!
in mixdown window select "locater range" and Auria will stop the mix at the
locater out point
best of luck- good sounds!
Re: Setting an end point
Thank you so much
Who is online
Users browsing this forum: No registered users and 4 guests