I'm pretty much a noob to DAWs and Auria, but slowly getting there...
Here is what I'm trying:
I have a short clip on track 1, and am sending it to Bus 1. Then track 2 gets its input from bus 1 so I can send it through an effect, and record it on track 2. However this doesn't work as I always get a track of silence. When I just loop it, the clip does go thru the effect... I just can't record it. Where have I gone wrong?
Noob using a bus
Re: Noob using a bus
Assuming I'm understanding what you're trying to do correctly, to 'print a track to tape' with its effects, you don't need to use a buss. Simply put the effect on track 1, then solo the track, tap on menu/mixdown and make sure that 'import as new track' is selected. This will create a new track with the effect rendered. If you want to render a buss' output, simply solo the tracks going into the buss, and the buss itself, and use the same mixdown technique.
Re: Noob using a bus
Tovokas - Thanks! Think I may have been thru this once before... Maybe it will "stick" this time!
Who is online
Users browsing this forum: No registered users and 149 guests